It is mid-summer, the sun is scorching hot, you’ve changed into your swimming clothes. Unfortunately, just when you’re about to jump into the pool, you see leaves and debris sitting at the bottom part of your pool.
Malfunctions in your pool cleaning system, like the leaves and debris situation above, can be caused by low water pressure. Some other signs of low water pressure are air bubbles and weak jets.
To avoid further damage to your pool system, you need to immediately fix the low water pressure issue. Luckily, we got you covered. Here are some tips to keep in mind to learn how to increase pool pressure.
How to Increase Pool Pressure
- Check your water pump
The water pump in your pool works by sucking the water from the pool through a pipe. After going through a filter, the water will be pushed back through another line into the pool.
If there’s any leak or blockage in your water pump, you will get low water pressure because the pump cannot suck and push water the way it should be.
This is where you should know that you must get the best pool pump and best pool filter. They will keep your pool system functioning correctly and keeps you away from frequent visits to the technician.
- Watch your water level
It would be best if you watched the water level in your pool, especially on hotter days, because the water typically evaporates faster.
Your water level should always be more than halfway up on the skimmer’s opening. If it gets below it, your water pump may experience trouble in the priming process. It can also lead to low water pressure.
- Check the skimmer and strainer baskets
Inside the skimmer basket, you will find all the debris from your pool. It will clog the water flow to the water pump when it has too much debris in it.
The same thing applies to the strainer basket. You have to check how much debris it has inside and throw the debris away whenever you think there’s already too much of it. Your water will always need enough water intake so that it can work properly.
Therefore, you need to clean your skimmer and strainer baskets regularly to keep optimum water circulation.
- Check your filter
Just like the skimmer and strainer baskets, your filter can get clogged too. Some everyday things that cause this issue are small debris and oily substances such as body lotion, sunscreen, and sebum. To clean your filter, there are two things you can do.
The first one is to soak it for a few hours in a TSP solution. Doing this will remove the grease and gunk from your filter.
After soaking it with the TPS solution, soak it again using a muriatic acid solution for total cleaning. Mix muriatic acid with water in a 1:10 ratio, and you will get any remaining minerals out of it.
- Check the pump’s impeller
You’ve cleaned all the baskets and filter yet you still get low water pressure? Maybe you need to check your pump’s impeller.
An impeller’s job is to push water out of the pump. However, when there’s too much debris around it, it won’t have the power to do so. This is why it is also essential to check and clean your pump’s impeller.
- Check for suction leaks
The piping and plumbing in your pool system have seals that are made from rubber. They will go bad over time and cause suction leaks.
Suction leaks typically happen in three areas. Those are the diverter valve, pump, and plumbing fittings. Whenever you feel like the water pressure in your pool is low, you should see if any of the seals need to be replaced.
Conclusion
Having an above ground pool in the comfort of your home is surely a pleasure. However, a pool needs regular maintenance so it can function well. If you think your pool’s water pressure is low, you can do the methods mentioned above.
Leave a Reply